Atlas Copco ALF Serie Consignes De Sécurité Et D'utilisation page 9

ALF 71, ALF 71-1, ALF 67/80, BMT 51
Protective equipment
Always use approved protective equipment.
Operators and all other persons in the working area
must wear protective equipment, including at a
minimum:
► Protective helmet
► Hearing protection
► Impact resistant eye protection with side protection
► Respiratory protection when appropriate
► Protective gloves
► Protective boots
Service and maintenance
Regular maintenance is a prerequisite for keeping
the machine safe and effective. Carefully follow the
operating instructions.
Before undertaking any maintenance or changing
the working tool on pneumatic machines, always
switch off the air supply and bleed the machine
by depressing the start and stop device. Then
disconnect the air hose from the machine.
► Use only authorised parts. Any damage or
malfunction caused by the use of unauthorised
parts is not covered by Warranty or Product
Liability.
► Change damaged parts immediately.
► Replace damaged and worn components in good
time.
► For major service to the machine, contact your
nearest authorised workshop.
► When cleaning mechanical parts with solvent,
make sure to comply with current health and
safety regulations and that there is satisfactory
ventilation.
Working tools
► Keep the tools clean and in good condition.
Regulary check the working tools, make sure that
they are sharp and not worn out.
Note! The machine can be destroyed if you use
incorrect working tools.
© 2006 Atlas Copco Construction Tools AB
www.CrowderSupply.com • Toll Free: 888-883-5144
| |
No. 9800 0681 71 2006-11-20
Safety and operating instructions
9