Frame Width - IRIS Quickie Mode D'emploi

ENG LI S H
68
Y. FRAME WIDTH
The frame of the IRIS is built to accommodate growth by using the growth kit components.
1) Fixed Strut Tube Width Adjustment (Rocker assembly)
a. Remove the bolts (A) from both ends of the strut tubes (B) for all strut tubes.
b. Replace with the appropriate length strut tubes
c. Tighten the bolts (A) at each end.
d. Repeat for each strut tube (B).
NOTE– Use a torque setting of 200 in.-lbs. when tightening hardware (A).
2) Fixed Strut Tube Width Adjustment (Roller assembly)
a. Remove the bolts (C) from both ends of the strut tubes (D) for all strut tubes.
b. Replace with the appropriate length strut tubes
c. Tighten the bolts (C) at each end.
d. Repeat for each strut tube (D).
NOTE– Use a torque setting of 200 in.-lbs. when tightening hardware (A).
3) Growable Strut Tube Width Adjustment (Rocker assembly)
a. Remove the hardware (E) from all three strut tubes (F) and adjust all three tubes an
equal distance.
b. When you are sure the width is equal for all three adjustable tubes, tighten the hardware
to a torque setting of 150 in-lbs after adjusting the strut tubes.
NOTE– Use a torque setting of 200 in.-lbs. when tightening hardware (A).
4) Growable Strut Tube Width Adjustment (Roller assembly)
a. Remove the hardware (G), (H), and (I) from the strut tubes.
b. Adjust all three tubes an equal distance, and re-tighten the hardware to a torque setting
of 150 in-lbs after adjusting the strut tubes.
NOTE– Use a torque setting of 200 in.-lbs. when tightening hardware (J)f
113373 Rev. E
69
70
71
28
IX. DEALER SERVICE & ADJUSTMENT
D
F
E
E
G
H
68
B
A
69
C
70
E
A
71
I
J