Hub Lock Adjustment; Wheel Locks; G.single-Post Armrest Receiver - IRIS Quickie Mode D'emploi

ENG LI S H
3. Axle Position Adjustment
a. Remove both wheels from the chair.
b. Remove the bolts (A) from the axle plate (B) on both sides of the chair.
c. Reposition the axle plate in desired position.
d. Insert and tighten bolts (A).
4. Axle Height Adjustment
a. Loosen and remove bolts (A).
b. Set axle at desired height using pre-set holes in the axle plate (B) on both sides.
c. Replace and tighten bolts.
E

. HUB LOCK ADJUSTMENT

To adjust the cables
1. Loosen jam nut (C) using a 10mm wrench.
2. Turn adjustment screw (D) in our out as necessary. Turning screw upward will loosen cable, turning
downward will tighten cable.
3. Re-tighten jam nut (C) against lever mount.
4. Repeat steps 1-3 for opposite side of chair as necessary.
To adjust lever position
1. Remove socket screw (E) and washer (F) from lever and backrest.
2. Choose desired hole in backrest to mount lever and re-install screw and washer.
3. Repeat steps 1-2 for opposite side of chair.
33
F. WHEEL LOCKS
Adjustment
a. Evenly loosen both screws (G). Do not attempt to remove one screw at a time.
b. Slide assembly toward rear wheel until clamp embeds into tire to prevent wheel movement, when in
locked position.
c. Tighten screws (G).
G. SINGLE -POST ARMREST RECEIVER
1. Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer armpost in the receiver:
a. Loosen the bolts on the sides of the receiver (J).
b. With the armrest in the receiver, squeeze the receiver to achieve the desired fit.
c. Tighten the four bolts (J).
2. Moving the Receiver location
a. Loosen the 3 bolts (I) holding the clamp halves(H) together (do not remove them)
b. Slide the clamp so that armrest is at the correct position.
c. Tighten the 3 bolts (I).
113373 Rev. E
31
31
32
34
IX. DEALER SERVICE & ADJUSTMENT
20
31
32
E
F
33
G
34
I
H
J