V2 CITY2+120V Mode D'emploi page 42

PARAMETER VALUE
SPAP
PAUS
ChiU
no
Ch.AU
no
0.5" - 20.0'
Ch.tr
no
0.5" - 20.0'
PA.tr
no
Si
LUCi
t .LUC
no
CiCL
AUS
t iM
biSt
Mon
SPiA
no
FLSh
W.L.
DESCRIPTION
Pedestrian Start during the partial opening phase
This menu allows fixing the control unit conduct in case it receives a
Pedestrian Start command during the partial opening phase.
m
WARNING: a Start command in any phase of partial opening will
cause the total opening; the Start Pedestrian command is always ignored
during a total opening.
The gate stops and goes to pause
The gate immediately starts closing
The gate goes on with the opening phase (command is ignored)
Automatic closing
Function deactivated
The gate closes after the setup time
Closing after transit
This function allows having a fast closing as soon as transit through the
gate is completed, therefore, a time shorter than
Function deactivated. The gate closes after the time set for the
Ch.AU
function
The gate closes after the setup time
Pause after transit
Per rendere minimo il tempo in cui il cancello rimane aperto, è possibile
fare in modo che il cancello si fermi non appena viene rilevato il passaggio
davanti alle fotocellule. Se abilitato il funzionamento automatico, come
tempo di pausa viene caricato il valore
Function deactivated
Function activated
Courtesy lights
This menu allows setting the automatic operating of the courtesy lights
during the opening cycle of the gate.
Timed operation (from 0 to 20 min)
Function disabled
On for the entire cycle duration
Auxiliary channel
This menu allows setting the operating of the relay of the lighting of the
courtesy lights by means of a remote control stored on the channel 4 of
the receiver.
Timed operation (from 0 to 20 s)
Bistable operation
Monostable operation
Low voltage output setup
This menu allows you to set the operation of the low voltage output.
Not used
Flasher operation (fixed frequency)
Indicator light operation: Indicates the status of the gate in real-time.
The type of blinking indicates the four possible conditions:
- GATE STOPPED: Light off
- GATE IN PAUSE: the light is on, fixed
- GATE OPENING: the light blinks slowly (2 Hz)
- GATE CLOSING: the light blinks quickly (4 Hz)
Ch.AU
is generally used
Ch.tr
- 40 -
DEFAULT MEMO
PAUS
no
no
no
CiCL
Mon
no