Jonsered CS 2245S II Manuel D'utilisation page 30

4. Tighten the saw chain until it is tight against the
guide bar but still can move easily.
5. Tighten the bar nuts using the wrench and lift the
front of the guide bar at the same time.
6. Make sure you can pull the saw chain around freely
by hand and that it does not hang from the guide
bar.
Note:
Product overview on page 2 for the
Refer to
position of the chain tensioning screw on your product.
To adjust the tension of the saw chain
(CS 2245S II, CS 2250S II)
WARNING:
incorrect tension can come loose from the
guide bar and cause serious injury or death.
A saw chain becomes longer when you use it. Adjust the
saw chain regularly.
1. Release the knob.
30
A saw chain with an
2. Turn the knob counterclockwise to loosen the clutch
cover.
3. Turn the chain tensioning wheel down (+) to increase
the tension of the saw chain. Turn the chain
tensioning wheel up (-) to decrease the tension of
the saw chain.
4. Turn the knob clockwise to tighten the clutch cover.
1049 - 005 - 21.06.2021