Hoshizaki Snowflake GII SUR-65BH Manuel D'utilisation, D'entretien Et D'installation page 10

Snowflake GII
__________________________________________________________________________________
When the cause of the alarm is no longer present, the cabinet will return to normal operation.
ACCESS TO ALARM HISTORY
1. Press the DOWN button for 2 seconds to show the first code
2. Press and release the UP button or select LS by pressing the DOWN button
3. Press and release the SET button: one of the codes above will be shown
To select an alarm, press the UP button till AH is shown.
To show alarm information, press and release the SET key (the flashing HACCP LED will stop).
DISPLAY TEXTS AND THEIR MEANING
8.0 Critical values 8.0 °C/°F
Dur The display shows the alarm time
h01 1-hour alarm (cont.)
n15 1 hour and 15-minute alarm
AH Selected alarm
To exit the historical display, press and release the ON/STANDBY button repeatedly.
To exit the process, repeatedly press the UP or DOWN buttons until the display shows the cabinet
temperature or wait 60 seconds without pressing any buttons.
Alternative Exit method: press and release the ON/STANDBY button. If there are no alarms recorded,
the LS code will not be displayed.
ERROR CODES
Code Description
Pr1 Cabinet probe error
Pr2 Evaporator probe error
The correction of these errors can only be undertaken by qualified technical personnel.
OPERATION STATUSES
Available operation statuses are listed below:
Status Description
ON
The cabinet is powered up and operating
STANDBY The cabinet is powered up but switched off
OFF The cabinet has no power, the plug is not in the socket,
or the main isolator is turned off
Do not carry out any maintenance or repair while the cabinet is in on or standby mode. Only when
the power supply is completely isolated from the cabinet can any works be done.
IMPORTANT
EN 10