Parker Maxi Plus MPXE 106 Mode D'emploi page 15

C) INSTALLING YOUR SYSTEM PNEUMATICALLY (See Figure 2)
9
4
3 5
2
8
10 8
7
6
1
Figure 2 - TYPICAL SINGLE BANK INSTALLATION
Install the dryer where the ambient air is as clean as possible and where the air temperature will never exceed
the dryers temperature limits.
PNEUMATIC CONNECTIONS
Connect the Inlet (1) and Outlet (2) compressed air lines to the valve housings marked Inlet and Outlet, ensuring
the protective dust covers fitted to the flanges on the PNEUDRI are removed prior to connection.
MANIFOLD & DRAINS
On installations with fabricated manifolds, an automatic drain valve must be fitted at the lowest point of the inlet
manifold to prevent condensate from entering the dryer.
14