Güde PMA 12-201-24 Traduction Du Mode D'emploi D'origine page 19

All manuals and user guides at all-guides.com
Symbols
WARNING / Caution!
Read the operating instructions to reduce
the risk of injury.
Wear eye protective goggles !
Wear ear protectors!
Wear gloves!
Take the replaceable battery from the
appliance before any extension, cleaning
and servicing works.
Class III tool.
CE marking
Any damaged or disposed electric or
electronic devices must be delivered to
appropriate collection centres.
V
Volts
n0
No-load speed
Direct Current
Battery
Protect the battery against heat and fire.
Protect the battery against water and
moisture.
Protect the battery against temperatures
above 40°C.
MAX 40°C
Do not throw the batteries in household
waste.
Li-Ion
Deliver the batteries to a collection centre of
old batteries where they will be recycled in
an environmentally friendly way.
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
Polisher safety warnings
Safety Warnings common for Polishing:
a) This power tool is intended to function as a
polisher. Read all safety warnings, instructions,
illustrations and specifi cations provided with
this power tool.Failure to follow all instructions
listed below may result in electric shock, fire and/or
serious injury.
b) Operations as sanding, abrasive and rough
grinding, and working with wire brushes are not
recommended to be performed with this power
tool. Operations for which the power tool was not
designed may create a hazard and cause personal
injury.
c) Do not use accessories which are not speci-
fically designed and recommended by the tool
manufacturer. Just because the accessory can be
attached to your power tool, it does not assure safe
operation.
d) The rated speed of the accessory must be at
least equal to the maximum speed marked on the
power tool. Accessories running faster than their
rated speed can break and fly apart.
e) The outside diameter and the thickness of
your accessory must be within the capacity rating
of your power tool. Incorrectly sized accessories
cannot be adequately guarded or controlled.
f) Treaded mounting of accessories must match
the grinder spindle thread. For accessories
mounted by flanges, the arbour hole of the
accessory must fit the locating diameter of the
flange. Accessories that do not match the mounting
hardware of the power tool will run out of balance,
vibrate excessively and may cause loss of control.
g) Do not use a damaged accessory. Before each
use inspect the accessory such as abrasive wheels
for chips and cracks, backing pad for cracks, tear
or excess wear, wire brush for loose or cracked wi-
res. If power tool or accessory is dropped, inspect
for damage or install an undamaged accessory.
After inspecting and installing an accessory,
position yourself and bystanders away from the
plane of the rotating accessory and run the power
tool at maximum noload speed for one minute.
Damaged accessories will normally break apart during
this test time.
h) Wear personal protective equipment. De-
pending on application, use face shield, safety
goggles or safety glasses. As appropriate, wear
dust mask, hearing protectors, gloves and shop
apron capable of stopping small abrasive or
ENGLISCH
15