INSTALLATION
WINDOW INSTALLATON
B
A
Window sill
A
Bottom bar
B
Side view
Carpenter's level
A
Window sash
B
Filler panel
C
A
B
C
D
F
G
H
E
Foam seal
Molding
A
D
Lower sash
Window Sill
B
E
Filler panel
Anti-theft screw
C
F
C
1" Wood screw
C
A
B
D
C
D
E
5/8" wood screw
D
Window sill
E
Chassis
G
Dec front
H
Window Installation
1.
Open window, by raising lower window sash, and mark
the center of window sill. Carefully place cabinet in
window and align center hole on the bottom bar with the
center mark on the window sill.
Close lower window sash until it touches behind the top
2.
bar. (Do not release your grip on the cabinet until the
lower window sash is in its final position).
Attach the cabinet to the window sill by driving one 1" long
3.
wood screw through the bottom bar into the window sill.
Be sure cabinet maintains an downward pitch. Air
conditioner should slant slightly downward on the
outside as shown by 1/2 a bubble off on a carpenter's
level. This outward pitch prevents water from entering the
room.
Securing the Filler Panels
Slide filler panels outward until they touch window sash
1.
tracks.
2.
Secure top of filler panels by driving a 5/8" wood screw
through each top mounting hole into window sash.
Secure bottom of filler panels by driving a 5/8" wood
3.
screw into window sill through each filler panel tab.
4.
Install chassis into cabinet.
Do not obstruct the air intake area of your air conditioner,
as this could cause overheating, thus activating the unit's
security switch and shutting off the unit. Do not block
aiflow inside with blinds, curtains, or furniture. Do not
block airflow outside with shrubs, enclosures, or other
buildings.
Installing the Chassis into the Cabinet
Slide the chassis into the cabinet.
1.
2.
Replace the two anti-theft screws at the bottom front sides
of cabinet.
3.
To replace the decorative front, line up the top tabs and
sides, and gently press into position. Reattach the screws
on both sides of the decorative front. Make sure the
power cord aligns with the power cord slot on the bottom
of the decorative front. Make sure the decorative front is
secure before reconnecting the plug and operating the
unit.
Cut plastic foam seal to width of window and install
4.
between upper and lower window sash.
5.
Use latex or silicone sealant (not supplied) to fill any
minor openings.
Do not drill a hole in the bottom pan. Unit is
designed to operate with approximately 1/2" of
water in bottom pan.
4
(cont.)