Care And Cleaning; Charcoal Filter; Hood Surfaces; Metal Baffle Grease Filter - GE Monogram ZV30H Manuel Du Propriétaire

Before servicing or cleaning the unit, switch power
For your
off at the service panel and lock the service panel to
safety
prevent power from being switched on accidentally.
If the service panel cannot be locked, fasten a tag
or prominent warning label to the panel.
If the hood is not vented to the outside, the air will
Charcoal
be recirculated through disposable charcoal filters
filter
that help remove smoke and odors.
(for use with
The charcoal filter should be replaced when it is
recirculation
noticeably dirty or discolored (usually after 6 to
mode only)
12 months, depending on hood usage).
nOte: DO NOT rinse, or put charcoal filter in an
automatic dishwasher.
the charcoal filters cannot be cleaned.
they must be replaced.
Order Charcoal Filter Kit (2 filters) :
WB02x11508 .
This kit can be ordered from GE parts. Please see
Consumer Services section for details.
Metal baffle
The metal baffles channel grease released by
grease filters
foods into the drip trays. The baffles also help pre-
vent flaming foods on the cooktop from damaging
the inside of the hood. For this reason, the baffles
must ALWAYS be in place when the hood is used.
The baffle grease filters should be cleaned once a
month, or as needed.
To remove the metal baffle grease filter, hold the
filter by both knobs. Push the filter into the front
(upper) filter channel until it is released from the
rear channel. Lower the back of the filter and
push away from the front channel until it clears.
These grease filters can be cleaned by hand or
in the dishwasher using non-abrasive soap. To
clean them by hand, soak and then swish them
around in warm water and detergent. Do not use
ammonia or ammonia products because they will
darken the metal. Do not use abrasives or oven
cleaners. Light brushing can be used to remove
embedded dirt. Rinse, shake and let dry before
replacing.
Do not use a steel-wool pad; it will scratch
Hood
the surface.
surfaces
To clean the stainless steel surface, use warm,
sudsy water or a stainless steel cleaner or
polish. Always wipe the surface in the direction of
the grain.
6

Care and Cleaning

Stainless Steel Hood
Tab
To install, align char-
coal filter with notch
on plastic blower cover
and turn filter counter-
clockwise to lock into
place. Make sure both
tabs are engaged and
filter is secure.
Rear channel
with grease tray
Filter
Filter
To replace the baffle grease filter, hold both filter
knobs while positioning the front end of the filter
into the upper (front) filter channel. Pull the filter
as far forward as possible into the channel. Push
the filter into the rear channel and adjust until it
seats properly.
Follow the cleaner instructions for cleaning
the stainless steel surface. To inquire about
purchasing stainless steel appliance cleaner or
polish or to find the location of a dealer nearest
you, please call our toll-free number:
national Parts Center:
To remove, turn filter
clockwise to disen-
gage both tabs and
pull gently.
Front
channel
Filter
800.626.2002