low
medium
high
3. The lights start flashing in sequence;
4. Press the button corresponding to the required
temperature:
low
5. The
button flashes to indicate that the selection has
been saved.
The appliance exits the menu and is ready for use.
4.2 Setting water hardness
The light (B7) indicating that the coffee maker needs descaling
comes on after a period of operation established according to
water hardness.
The appliance can also be programmed according to the hard-
ness of the mains water in the various regions so that descaling
needs to be performed more or less frequently.
Proceed as follows:
1. Access the settings menu;
2. Press the
button to enter the water hardness selec-
tion mode. The lights corresponding to the current selec-
tion come on:
soft
medium
hard
3. The lights start flashing in sequence;
4. Press the button corresponding to the water hardness in
your area:
soft water
<10°dH
10°dH - 20°dH
<18°fH
18°fH - 36°fH
<180mg/l CaCo
180-360mg/l CaCo
3
-
The
button flashes to indicate that the selection has
been saved.
The appliance exits the menu and is ready for use.
medium
high
medium
hard water
water
>20°dH
>36°fH
>360mg/l CaCo
3
4.3
Adjusting auto-off (stand-by)
To save energy, an auto-off function turns the appliance off
when not used for a long period. To turn it back on again, press
any button on the control panel.
1. Access the settings menu;
2. Press the
mode. The lights corresponding to the current selection
come on:
3. The lights start flashing in sequence;
4. Press the button corresponding to the required time:
9 min
5. The
button flashes to indicate that the selection has
been saved.
The appliance exits the menu and is ready for use.
4.4 Default values (reset)
This resets all menu settings and programmed quantities back
to the default values.
To reset the default values, proceed as follows:
1. Position the steam spout over the drip tray;
2. Access the settings menu;
3. Turn the steam dial to the
4. Press the
neously to confirm that the original settings have been
restored.
5. The
and
steam dial must be closed again ( ○ symbol).
When the steam dial has been closed, the appliance is ready for
use.
5. HOW TO MAKE ESPRESSO COFFEE
5.1 Tips for a hotter coffee
For hotter espresso coffee, you should:
•
You are recommended to warm the cups before making
coffee by rinsing them with a little hot water.
•
Attach the filter holder to the appliance with the filter in
3
place but without adding coffee. Using the same cup
as will later be used to make the coffee, press the 1 cup
button and deliver hot water into the cup to heat it.
•
Raise the coffee temperature in the settings menu.
7
button to enter the auto-off time selection
9 min
30 min
3 hours
30 min
3 hours
position;
button. The three lights flash simulta-
lights flash to indicate that the