La Marzocco micra Serie Manuel page 13

WARNING
The Coffee group and steam
boiler contain water at elevated
temperature. Water temperature
over 125°F / 52°C can cause
severe burns instantly or death
from scalding (Coffee group
200°F/93.3°C - steam boiler
260°F / 127°C).
WARNING
The machine must not be dipped in,
nor splashed with, water in order to
clean it. For cleaning operations,
please follow the instructions listed
below very carefully.
WARNING
This machine is designed only for
preparing coffee and hot drinks.
WARNING
To avoid the risk of injury, do not
open the brew chamber during
the brew process.
WARNING
Do not touch the steam wand
while dispensing steam and for
40s from the end of dispensing.
1. Installing the portafilter.
Install the portafilter by inserting it into
the Coffee group and rotate the handle
from left to right. Once the portafilter
is inserted properly, you can move the
paddle handle from right to left to start
the flow of water through the portafilter.
It is important that the portafilter is at
operating temperature prior to filling with
coffee.
Portafilter
Figure 3 - Portafilter
Allow hot water to pass through the empty
portafilter for a few seconds before the
brewing process to pre-heat the portafilter.
NOTE:
It is important to leave the portafilter
locked in the espresso machine when
not in use. The portafilter must remain
heated for the brewing process to function
correctly.
2. Brewing coffee.
remove the portafilter to make a coffee
beverage. Place some ground coffee in the
portafilter basket using the single or double
basket. Press down on the ground coffee
with the supplied tamper and install the
portafilter on the micra. Move the paddle
handle from right to left to begin brewing
Filter
(see Fig.1 page 8).
basket
With the La Marzocco App it is possible to
Spring
adjust the temperature of the coffee brewing
water.
It is recommended to wait for a few
seconds until the desired temperature is
achieved.
If you want to decrease the temperature,
Double
it is recommended to dispense water from
snap-on
the group for a few seconds to speed up
spout
the process.
5. Operation
It is now possible to
13