Makita DHR202ZJ Manuel D'instructions page 5

ENGLISH (Original instructions)
1. Red indicator
2. Button
3. Battery cartridge
4. Star marking
5. Switch trigger
6. Lamp
7. Reversing switch lever
8. Rotation with hammering
9. Lock button
10. Action mode changing knob
11. Rotation only
12. Hammering only
SPECIFICATIONS
Capacities
No load speed (min
Blows per minute
Overall length
Rated voltage
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone as well as for chiselling work.
It is also suitable for drilling without impact in wood, metal,
ceramic and plastic.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS ROTARY HAMMER
SAFETY WARNINGS
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
Explanation of general view
13. Grip base
14. Teeth
15. Side grip
16. Protrusion
17. Loosen
18. Tighten
19. Bit shank
20. Bit grease
21. Bit
22. Chuck cover
23. O symbol
24. Depth gauge
Model
Concrete
Steel
Wood
-1
)
Net weight
accessory contacting a "live" wire may make exposed
ENE043-1
metal parts of the power tool "live" and could give the
operator an electric shock.
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly
recommended that you wear a dust mask and
thickly padded gloves.
GEA010-1
5. Be sure the bit is secured in place before
operation.
6. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
7. In cold weather or when the tool has not been
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm-
up, hammering operation is difficult.
8. Always be sure you have a firm footing.
GEB046-2
Be sure no one is below when using the tool in
high locations.
9. Hold the tool firmly with both hands.
10. Keep hands away from moving parts.
11. Do not leave the tool running. Operate the tool
only when hand-held.
12. Do not point the tool at any one in the area when
operating. The bit could fly out and injure
someone seriously.
25. Dust cup
26. Blow-out bulb
27. Chuck adapter
28. Keyless drill chuck
29. Sleeve
30. Ring
31. Limit mark
32. Recessed part
33. Holder cap cover
34. Brush holder cap
35. Screwdriver
BHR202
20 mm
13 mm
26 mm
0 - 1,200
0 - 4,000
358 mm
3.5 kg
D.C. 18 V
5