Danfoss ERC 211 Guide D'installation page 9

5 - Quick Configuration via "cFg" Menu
y
Press SET for three seconds to access the parameters groups.
y
Select "CFg" menu and press SET to enter. The first menu "r12" (main switch) is displayed.
y
Switch OFF main switch (r12=0) for changing the pre-installed application.
y
Press UP/DOWN to scroll through the parameter list.
y
Configure the "o61" parameter to select a pre-installed application
- Press SET to access the "o61" parameter.
- Press UP/DOWN to select an application (AP0= no application selected).
- Press SET to confirm, "o61" is displayed.
y
Continue to set the next parameters ("o06" sensor type) in the "cFg" menu.
DKRCE.PI.RL0.F7.ML Installation Guide | ERC 211
| 9