Publicité
Les langues disponibles
Les langues disponibles
OPERATION - Ventilation
1. Set the fan on a level surface, such as a table.
2. Tilt the fan to the required angle (see Figure
2). You can set the fan:
a. to blow horizontally (position A) or angled
slightly downwards (position B). Turn
the locking screws a little bit loose first
(see figure 2) Tilt the ventilator housing
and motor housing to the required angle.
(with a sweep of 10°). Tighten the locking
screws again.
b. to oscillate from left to right (with a sweep
of 90°). This will ventilate much of the
room. Pull out the oscillation button until
you hear it click.
c. remain in the same position whilst the
fan is turning. This will ventilate one area.
Press the oscillation button on the motor
housing fully in.
3. Put the plug into the wall socket.
4. Switch on the fan by turning the speed dial.
a. Position 'I': the fan operates at low speed.
b. Position 'II': the fan operates at normal
speed.
c. Position 'III': the fan operates at high
speed.
5. Stop the fan by turning the speed dial to
position '0'.
6. Switch off the appliance after each use and
remove the plug from the wall socket.
CLEANING AND MAINTENANCE
Over the course of time dust can accumulate between the spokes in the fan housing, and on the fan
blades. Always begin by trying to remove the dust with a brush and/or vacuum cleaner. If this does not
remove all the dust you can always dismantle the fan and clean it.
WARNING:
•
Verify that the appliance is not connected to the power supply before you clean it.
•
Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to
clean the appliance.
Reassemble the fan using the procedure given under by 'Assembling'.
25
EN
A
B
Publicité
