Publicité
Les langues disponibles
Les langues disponibles
7.2
PLACE THE MOWER UPRIGHT IN
VERTICAL POSITION
G
14
13
1. Place the mower upright in vertical position.
2. Remove the packing material from the cable.
3. Remove the rubber edge guard (G) from the upper
handle.
4. Insert the upper handle into the lower handle.
5. Put the bolts (13) through the holes and tighten with the
nuts (14), using a Philips head screwdriver (not included).
WARNING
Do not damage the cable while installing the upper handle.
English
7.3
14
13
15
1. Pull up on the handle holes (15) to release the lower
handles.
2. Fold the lower handle up until the handle pins (16) lock
into position.
Make sure that the two handle pins are in the same position.
7.4
17
1. Remove the mulch plug.
2. Remove the side discharge chute.
3. Open the rear discharge flap (7) and hold it.
4. Hold the the grass catcher by its handle and engage the
hooks (17) on the door rod (18).
5. Close the rear discharge flap.
9
UNFOLD THE LOWER HANDLE
16
NOTE
INSTALL THE GRASS CATCHER
18
EN
7
18
Publicité
