Snap-On EEWH337A Mode D'emploi page 22

A
22
6-1
6-2
B
6-3
Snap-on EEWH337A
6.0 maintenance
WARNING
BEFORE ATTEMPING ANY MAINTENANCE OR
REPAIRS THE MACHINE MUST BE DISCONNECTED
FROM THE AIR AND ELECTRIC SUPPLY.
A. Periodically clean the vertical hexagonal rod with
nonfl ammable liquid detergent. Lubricate with oil (Fig.
6-1).
B. Periodically clean all moving metal parts and lubricate
with oil.
C. Clean the teeth of the clamps with a wire brush, check
the plastic rim protectors and replace if worn (Fig. 6-2).
D. Peridically replaced the plastic insert inside mount/
demount tool.
E. Lubricate rods of air cylinders with oil as needed.
F. Periodically wash all plastic parts with cold water and
soap or window cleaner.
G. Check the bead breaker pads. Replace if worn.
H. Discharge the water every day from air fi lter
I. The machine is equipped with an automatic lubricator.
Check the oil level weekly (Fig. 6-3).
When adding oil to the lubricator, disconnect the air supply
fi rst, remove the fi ll screw 'A', and add oil as needed.
Make sure seals are in place when repositioning the cup
Drain water daily from water separator. Do this by pulling
down the fi tting 'B'.
NOTE: Keep the oiler fi lled.
WARNING!
USE ONLY THE SPECIFIED OIL BELOW. DO NOT
USE BRAKE FLUID OR OTHER NOT SUGGESTED
LUBRICANTS.
Suggested oils for the fi lter/lubricator unit:
Snap-on Air Tool Oil IM1PT
EN