Publicité
Les langues disponibles
Les langues disponibles
BACHMANN EUROPE PLC
Uncoupling the units
To uncouple ( Fig. 2 b ) press the
coupling hook ( H ) downwards
by using a screwdriver from the
side and separate the units.
The -part basic model of the
DOMINO can also be expanded
by adding the intermediate car
set units D, E ... to from a reali-
stic multiple unit.
The intermediate cars in the
multiple unit can be arranged in any fashion just like the original. The coupling arrangement
prevents units being connected contrary to a real-life situation.
Putting your DC model into operation
Once the units have been cou-
pled, the multiple unit is ready
to run.
The DC model in its default set-
ting has been connected so that
the power pick-up is effected via
the wheels of the two end cars.
If you like to change the default
setting it is possible as follows:
Three switches are located on
the main circuit board directly
under the roof of Unit A. To
operate these switches you must
pull the small resistor cover (W )
upwards ( Fig. 3 ).
H0 1:87
Betra_L133940_59_D_GB_F.indd 15
H
W
S1
S 3
Figure 2b
S2
Figure 3
1
09.03.2011 10:12:39 Uhr
Publicité
