Publicité
Les langues disponibles
Les langues disponibles
LILIPUT hopes that your DOMINO model will give you a lot of pleasure.
Preparing your model
Please carefully remove the individual units out of the blister packaging. The units A and
B each come with a motor. However, only unit A (with pantograph) (Fig. 1) can be driven
individually for test purposes. Unit B only runs when connected with the other units.
Unit B
Coupling the Units
The models are fitted with special electrically conducting couplings. Place the rail car unit
A (with pantograph) and intermediate car unit C at a slight distance from each other on
the rails. In general, always make sure when coupling two units that two different coupling
parts (with and without coupling hook) ( H ) as per (Fig. 2) are facing each other.
Now carefully push the units
towards each other until the
couplings touch. We recom-
mend slightly raising the two
ends of the cars (about cm)
from the rails and to rest the
coupling hook ( H ) as shown
in (Fig. 2 a) on a finger. This
allows the two couplings to
be gently interconnected until
the coupling hook enga-
ges without one part being
pressed downwards.
Repeat the procedure to
couple the control cab car
unit B to the intermediate car
unit C.
1
Betra_L133940_59_D_GB_F.indd 14
BACHMANN EUROPE PLC
Unit C
Figure 2
Figure 2a
Unit A
H
H
09.03.2011 10:12:39 Uhr
Figure 1
H0 1:87
Publicité
