Publicité
Les langues disponibles
Les langues disponibles
C A R E & M A I N T E N A N C E
Battery Installation
1.
Turn the vacuum off. Press the Battery
Release Button and remove the battery.
2.
To reinstall, slide the battery into the slot in
the vacuum body. [Figure 2.1] There will
be a clicking sound when the battery is
properly installed.
Note:
•
To maintain the life of the battery, store the
vacuum in a cool, dry place.
•
Store the battery in a semi-charged state
(at least 2 battery indicator lights) and
maintain this by charging the battery every
3 months.
Figure 2.1
Charging the Vacuum
Your vacuum uses a 2200mAh Li-ion battery.
Use the included charger to charge the
vacuum.
Note: Make sure the vacuum is turned off
before charging.
1.
Install the wall mount by screwing it into
the wall near a power outlet. [Figure 2.2]
Note:
•
The wall mount must be high enough on
the wall to allow the vacuum to stand up.
•
Make sure that the wall is free of gas
pipes, water pipes, electrical cables, and
wires.
Figure 2.2
EN
9
Publicité
