Problem
Vacuum releases a bad
or unusual smell.
If your problem is not listed, please contact
F E D E R A L C O M M U N I C AT I O N C O M M I S S I O N I N T E R F E R E N C E
S TAT E M E N T – PA R T 1 5
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
F C C S D O C S U P P L I E R ' S D E C L A R AT I O N O F C O N F O R M I T Y
Arovast Corporation hereby declares that this equipment is in compliance with FCC requirements.
The declaration of conformity may be consulted in the support section of our website, accessible from
www.levoit.com
CAN ICES-003 (B) / NMB-003 (B)
Possible Solution
The environment's relative humidity may be high or the vacuum may
have absorbed water and caused the filter to grow mold. Replace
the filters (contact Customer Support, page 20).
The filters may be dirty. Clean the filters (see Cleaning, page 12).
The dust bin may be dirty. Empty and clean the dust bin (see
Cleaning, page 12).
Customer Support (see page
EN
20).
17