Publicité
Les langues disponibles
Les langues disponibles
CLEANING (CONT.)
Cleaning the Pre-Motor &
Post-Motor Filters
To maintain the performance of your filters, they
should be routinely washed and replaced.
•
If you notice decreased suction power,
or the filter is visibly dirty, clean the filter
immediately.
•
The pre-motor filters (foam filter and felt
filter) should be washed at least once a
month and replaced every 3 months.
•
The post-motor filter should be washed
at least once a year.
•
Do not
put filters in a dishwasher,
washing machine, tumble dryer, oven,
or microwave, or place near an open
flame.
•
Never
operate the vacuum without the
dust bin or filters properly installed.
•
Frequent use may require cleaning the
filters more often. Cleaning the filters
regularly helps maintain your vacuum's
cleaning performance.
•
You may need to replace the filters
more frequently depending on your use
and environment.
•
If the surrounding humidity is high,
please allow the filters to air-dry for a
longer period of time before reinstalling
them back into the vacuum.
Replacement Filters:
•
To maintain the performance of your
vacuum,
only
use official Levoit filters.
For more information, contact
Support
(see page 20).
Pre-Motor Filters
To maintain the performance of your filters, they
should be routinely washed and replaced.
Customer
1.
Press the Dust Bin Release Button to
remove the dust bin. [Figure 3.3]
2.
Remove the two pre-motor filters (foam
filter and felt filter). [Figure 3.4]
3.
Clean the pre-motor filters with water.
Allow the filters to air-dry completely
under the sun or in a dry, ventilated
place before reinstallation.
4.
Replace the foam filter, followed by the
felt filter.
Note: Make sure the felt filter has the ribbon-
handle side facing outward when you insert
the filter.
5.
Place the dust bin back onto the
vacuum body.
Figure 3.3
Figure 3.4
EN
13
Publicité
