Publicité
Les langues disponibles
Les langues disponibles
EN
CLEANING (CONT.)
Post-Motor Filter
1.
Press the Dust Bin Release Button to
remove the dust bin. [Figure 3.5]
2.
Pull out the post-motor filter (high-
efficiency paper) from the vacuum
body. [Figure 3.6]
3.
If necessary, run post-motor filter under
running water to wash it. [Figure 3.7]
Allow the filter to air-dry completely
under the sun or in a dry, ventilated
place before reinstallation.
4.
Push the post-motor filter back in the
vacuum body until you hear a click,
then replace the dust bin.
Figure 3.6
14
Figure 3.5
Figure 3.7
Cleaning the Roller Brush
Periodically check the roller brush for hair or
debris. The roller brush will automatically shut
off if it is blocked or jammed.
1.
Turn the vacuum off. Detach the
vacuum head from the stick by
pressing the Vacuum Head Release
Button.
2.
Press the Roller Brush Release Button,
slide the side panel up to open, then
pull out the roller brush. [Figure 3.8]
3.
If the roller brush is jammed, carefully
use a pair of scissors or a sharp knife
to remove any hair or debris tangled
around the roller brush.
4.
Insert the roller brush back into the
vacuum head. Slide the side panel
down to lock it in place.
Figure 3.8
Publicité
