Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
3. Attach blades
Fig. A. Slide blade assembly over motor shaft. Ensure blade assembly is fully seated onto shoulder of shaft and
set screws are aligned to flats of shaft as shown. Tighten set screws to 20 ft·lb (27.1 N·m) using 5/32 in. hex drive.
Fig. A
Tighten to 20 ft·lb
(27.1 N·m)
4. Install front guard
Fig. A. Align hinge pin eyelets on front guard and rear guard.
Fig. B. Fasten front guard to rear guard using hinge pins, starting with topmost hinge.
Fig. A
Fig. B
4
WWW.BIGASSFANS.COM
© 2017 DELTA T LLC
ALL RIGHTS RESERVED.
Publicité
