Samsung RSG307 Serie Mode D'emploi page 7

SETTING uP ThE REFRIGERATOR
DOORS
If your entrance won't allow the refrigerator to pass
easily through it, you can remove the doors.
Separating the Water Supply Line from the
Refrigerator
1. Pull the two water lines (which are in the Fixer) out
to the front.
2. Remove two water lines (White one is for water
and the other one is for ice) by pressing the
coupler and pulling the water line
1
Make sure the color of
the water lines match.
Removing the freezer door
A few things to mention first.
• Make sure that you lift the door straight up so the
hinges are not bent or broken.
• Be careful not to pinch the water tubing and wire
harness on the door.
• Place doors on a protected surface to prevent
scratching or damage.
1. With the Freezer door closed, remove the upper
hinge cover using a screwdriver, and then
1
disconnect the wires by gently pulling them apart
.
2
1
2. Removing the FIXER HINGE ,and next take off the
away.
2
1
2
2
upper hinge. Be careful that the door does not fall
on you as you are removing it.
Be sure to keep track of all parts you are
removing.
3. Next, remove the door from the lower hinge
carefully lifting the door straight up
4
3
Be careful not to pinch the water tubing and
wire harness on the door.
Reattaching the freezer doors
To reattach the freezer doors, replace parts in reverse
order
Reattaching the Water Supply Line
1. The Water Line must be fully inserted to the
marked line to prevent water leakage from the
dispenser.
2. Insert the 2 clips in the install pack and check that
each clip holds the line firmly.
Line
coupler
clip A (¼")
coupler
Do not cut the water line. Gently separate it
from the coupler.
by
3
.
4
Line
coupler
clip A (¼")
coupler
setting up _07