Publicité
Les langues disponibles
Les langues disponibles
check the amount of water supplied to the ice
tray.
1. Lift up the icemaker cover and gently pull it out.
2. When you press the Test button for 3 seconds,
the ice cube container is filled with water from the
water supply tap. Check to make sure the amount
of water is correct (see the illustration below). If the
water level is too low, the ice cubes will be small.
This is a water pressure problem from within the
main water pipes, not the refrigerator.
1
Ice maker
Test button
- It will take a few minutes for the water to
reach the correct level after you push the
cAuTION
Test button.
-
Do not press the test button continuously when
the tray is filled with ice or water. Water may
overflow or ice jamming may occur.
-
When the bucket is not installed, the ice maker
does not work.
-
When Ice Off blinks on the display panel, reinsert
the bucket and/or make sure it's installed properly.
check the water
level
2
setting up _11
Publicité
