Blue Sky Outdoor Living OKCSST26 Manuel Du Propriétaire page 7

the top. Do not use a knife or sharp object to remove the film.
If you start at a side edge and pull slowly, the protective film
will release from the top.
To secure the top, (you will need to do this from the inside of
the cabinets), bolt the top flanges that are inside the cabinet
bodies to the outer side panels of the cabinets and bolt the
Top Brakets and cabinet frame to the top.
Using 20 bolts (I) for the double wide tops (OKCSTT6026
and OKCSTT6036), 2 on each of the outside panels of the
two cabinets and 8 on the remaining three sides that screw
upwards into the top from each cabinet.
Using 30 bolts (I) for the Triple wide tops (OKCSTT9026
and OKCSTT9036),2 on each of the outside panels of the
three cabinets and 8 on the remaining three sides that screw
upwards into the top from each cabinet.
Finger tighten the bolts in place. Then tighten all the bolts
using either the hex key or the bit and extender that are
included in the Cabinet Hardware Bag. Using your drill, may
make some of these fasteners easier to install. Be sure not
to over tighten.
DETAIL AND FINISHING
With the cabinet(s) assembled and in place, check to make
sure the unit(s) are still level. Adjust the leveling feet if
needed. This is a two to four person job depending on the
number or cabinets bolted together, one to three people to
tip the cabinet back slightly and one to adjust the leveling
feet. The cabinets should be levelled so the front is sightly
higher than the back.
Continue to assemble your cabinet per cabinet instructions.
7 | www.bluesk youtdoorliving.com