Blue Sky Outdoor Living OKCSST26 Manuel Du Propriétaire page 6

DOUBLE AND TRIPLE CABINET
TOP ASSEMBLY
When installing the Double or Triple Wide Stainless Steel
Top (OKCSST6026, OKCSST9026, OKCSST6036 or
OKCSST9036) make sure to bolt the cabinets together
before installing the multiple cabinet tops. With two people
Level and bolt together the two or three fully assembled
cabinets through the four locations on each side panel using
four bolts (P) and four nuts (Q) included with your cabinets.
Once your double or triple cabinets are bolted together,
install 2 top brackets (J) for your Double cabinet set up and
4 top brackets (J) for your triple cabinet setup. Bolt the top
bracket (J) to the top of each interior side panel with 2 bolts
J
(I) per bracket as shown.
J
J
With four or six people, for the triple wide tops, lift your
Stainless Steel top in place over the cabinets body with the
arrow sticker pointing to the back of the cabinet. The flanges
on the bottom sides of the top should slide into place inside
the edges of the cabinet. You may need one person to push
the center of the sides of the cabinet out (the hinge may have
folded in a little) to make sure the flanges are all inside the
body of the cabinet.
The cabinet body has a snug fit to the cabinet top, you may
need a flat head screwdriver to guide one side of the top into
place from the inside of the cabinet or use a rubber mallet
to gently tap from the inside so that the top sits flat on the
cabinet body. Remove any remaining protective film from
6 | www.bluesk youtdoorliving.com