Blue Sky Outdoor Living OKCSST26 Manuel Du Propriétaire page 5

OKCSST36- Sink
CABINET SOLD SEPARATELY
CABINET SOLD SEPARETLY
After assembling cabinet and base per cabinet instructions, install the
After assembling cabinet and base per cabinet instructions, install
Stainless Steel top using the below top installation instructions. Before you
the Stainless Steel top using the top installation instructions
install the stainless steel top make sure to remove all drawers and or shelves.
below. Before you install the stainless steel top make sure to
Use your cabinet manual for drawer and shelf removal and reinstallation
remove all drawers and or shelves. Use your cabinet manual for
drawer and shelf removal and reinstallation instructions.
instructions.
Before you install the stainless steel top you should peel up the
Before you install the stainless steel top you should remove the protective
protective plastic from the edges of the top.
plastic from the edges of the top.
Tip: It is easier to start removing the protective film from a
corner edge of the top. As you pull, use both hands so you are
pulling more the the plastic film all at the same time. Slow and
With two people lift the top (A) in place over
steady will remove the film in larger pieces.
the cabinet body with the sticker pointing to
the back of the top towards the back of the
SINGLE CABINET TOP ASSEMBLY
cabinet. The flanges on the bottom sides
of the top should slide into place inside the
Note: Do not bolt multiple cabinets together before installing
edges of the cabinet. You may need one
single cabinet tops.
person to push the center of the sides of the
With two people lift a single top (OKCSST26, OKCSST26-Sink,
cabinet out (the hinge may have folded in a
OKCSST36 or OKCSST36-Sink) in place over the cabinet body
The cabinet body has a snug fit to the cabinet
with the arrow sticker on the top pointing towards the back of the
little) to make sure the flanges are all inside
top, you may need a flat head screwdriver to
cabinet. The flanges on the bottom sides of the top should slide
the body of the cabinet.
into place inside the edges of the cabinet. You may need one
guide one side of the top into place from the
person to push the center of the sides of the cabinet out from
inside of the cabinet or use a rubber mallet
the inside (the hinge may have folded in a little) to make sure the
to gently tap from the inside so that the top
flanges are all inside the body of the cabinet.
sits flat on the cabinet body. Remove any
The cabinet body has a snug fit to the cabinet top, you may need a
remaining protective film from the top. Do not
flat head screwdriver to guide one side of the top into place from
use a knife or sharp object to remove the film.
the inside of the cabinet or use a rubber mallet to gently tap from
5 | www.bluesk youtdoorliving.com
If you start at a side edge and pull slowly, the
the inside so that the top sits flat on the cabinet body. Remove
any remaining protective film from the top. Do not use a knife or
protective film will release from the top.
sharp object to remove the film. If you start at a side edge and pull
slowly, the protective film will release from the top.
To secure the top, (you will need to do this
from the inside of the cabinet), bolt the top
To secure the top, (you will need to do this from the inside of the
cabinet), bolt the top flanges that are inside the cabinet body,
flanges that are inside the cabinet body, to the
to the body of the cabinet. With 10 bolts (I), two on each side
body of the cabinet. With 10 bolts (B), 2 on
and three on the front and the back that screw upwards into the
each side and 3 on the front and the back that
top. Finger tighten the bolts in place. Then tighten all the bolts
screw upwards into the top. Finger tighten the
using either the hex key or the bit and extender that are included
bolts in place. Then tighten all the bolts using
in the Hardware Bag. Using your drill, may make some of these
fasteners easier to install. Be sure not to over tighten.
either the hex key or the bit and extender that
are included in the Hardware Bag. Using your
drill, may make some of these fasteners easier
to install. Be sure not to over tighten.
DETAIL AND
FINISHING
5 | www.bluesk youtdoorliving.com
36" Extended Sink Top