Danfoss RET2001B Manuel D'installation page 4

Installation Guide
1 . Installation Steps
EN
User Guide can be downloaded from: heating.danfoss.com.
1 . Installation must be done by an authorised
electrician .
2 . The room thermostat should be installed at approx .
1 .5 m above floor and where the effects of sunlight,
draught or other heat sources (eg . TV's) are avoided,
see fig . 1 on page 44 .
3 . First loosen lower retaining screw and carefully
remove back plate, see fig . 2 on page 44 .
4 . Mount back plate direct to wall or on wall box and
wire according to application, see fig 3 on page 44 &
fig 5 on page 45 according to application .
5 . Insert 2x AA Alkaline batteries to front part taking
care to insert correctly as indicated .
6 . Locate hooks at top of front part into top of back
plate and lower into position and tighten retaining
screw .
2 . Dimensions and Wiring
See fig . 4 for dimensions and fig . 5 for wiring diagram
on page 45 .
4 Danfoss Climate Solutions | AN30483451554601-010102 | 06/2023
RET2001B & TP5001B