Velleman WB059 Mode D'emploi page 6

1. Safety Instructions

Read the entire instruction manual before you start installation and assembly.

Do not begin the installation until you have read and understood the instructions and warnings contained in
this installation sheet.

If you have any questions regarding any of the instructions or warnings, please contact your local
distributor.

This mounting bracket was designed to be installed and utilized only as specified in this manual.

Improper installation of this product may cause damage or serious injury.

This product should only be installed by someone of good mechanical ability, with basic building
experiences and fully understanding of this manual.

Make sure that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.

Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

Tighten screws firmly, but do not overtighten.

Overtightening can damage the items, greatly reducing their holding power.

This product is intended for indoor use only.

Using this product outdoors could lead to product failure and personal injury.
2. Component Checklist – Important
See images.

Ensure that you have received all parts according to the component checklist prior to installing. If any parts
are missing or faulty, contact your local distributor for a replacement.

Mounting hardware not included.
3. Mounting
See images.
3.1 Wood stud wall mounting

Make sure that the mounting screws are anchored in the centre of the studs.

The use of a stud finder is highly recommended.

Installers are responsible for providing hardware for other types of mounting situations.

The installer must verify that the supporting surface will safely support the combined load of the equipment
and all attached hardware and components.
3.2 Solid brick and concrete mounting

Mark the exact location of mounting holes.

Drill pilot holes.

Screw the wall mount onto the wall.

Slide the L-shaped holder along the wall plate rail until the hole in the holder is aligned with the last hole
but one in the wall plate.
3.3 Installing the VESA plate.

Screw the VESA plate onto the TV.

Tighten all screws but do not overtighten.
3.4 Hanging the TV onto the wall plate

Carefully lift your TV and hook the VESA plate onto the mounted head.

Insert two screws in the mounting holes.

Tighten all screws using the allen key.
3.5 Cable management

Connect the cables to your TV and run them through the wire saddle. Note: leave slack in cables to allow
for arm movement.
V. 2 – 25/09/2019
WB059
USER MANUAL
6 ©Velleman nv