EGO HTA2020 Guide D'utilisation page 27

15. Mount the bottom cover onto the gear case and secure it with 6 short screws
(Fig. 17).
17
Support Plate 3
16. Start the hedge trimmer to check whether the hedge trimmer can work normally.
If it does not, reassemble following the above steps.
SHARPENING THE BLADE
When cutting performance and behavior begin to deteriorate, re-sharpen the blades. It
is recommended to have the blades re-sharpened by a qualified service technician.
NOTICE:
Do not operate your hedge trimmer with dull or damaged blades. This may
cause overload and will give unsatisfactory cutting results.
HEDGE TRIMMER ATTACHMENT — HTA2000/HTA2000-FC/HTA2020/HTA2020-FC
Link Lever
Bulge
Short Screw
Bottom Cover
27