Publicité
Les langues disponibles
Les langues disponibles
10. Mount the support plate 1 and then mount the support plate 2.
11. Keep the inside holes in the blade, the bushings, and the holes in the support
plates in line with the screw holes in the gear case. Install the 2 long screws into
the aligned holes and tighten them securely (Fig.15).
15
Long Screw
Support Plate 2
Support Plate 1
Inward Bulge
Outward Bulge
12. Slightly move the upper blade
back and forth to check whether
the blade can move freely. If not,
reassemble the blades until the
upper blade can move freely.
13. Install the link lever with its bulge
facing the blade (Fig.16).
14. Align the hole of support plate 3
with the bulge on the eccentric
block assembly to install the support plate into place, ensuring that the plate is
exactly located in the center, parallel to both edges.
26
HEDGE TRIMMER ATTACHMENT — HTA2000/HTA2000-FC/HTA2020/HTA2020-FC
Bushing
Rounded Rectangle Slots
Screw Holes in the Gear Case
Hole inside the Eccentric Block Assembly
16
Bulge on the Link Lever
Bulge on the Link Lever
Link Lever
Publicité
