Télécharger Imprimer la page

EGO HTA2020 Guide D'utilisation page 25

Taille-haie amovible exclusivement pour utilisation avec la tête d'alimentation ph1400/ph1400-fc/ph1420/ph1420-fc

Publicité

Les langues disponibles

Les langues disponibles

REPLACING THE BLADE
WARNING:
very sharp and may contain burrs.
14
1. Stop the motor and remove the battery pack.
2. Adjust the blade to the horizontal position, ensuring that the blade assembly is in
line with the hedge trimmer shaft for easy mounting (Fig. 14).
3. Use a hex wrench (not included) to loosen the 6 screws (short screws) in the
bottom cover and remove them.
4. Continue loosening the 2 screws (long screws) to remove the support plate 1 & 2,
as well as the 2 bushings. The 2 bushings are separately located inside the two
rounded rectangle slots in the blade assembly.
5. Remove the support plate 3.
6. Carefully remove the link lever from the blade.
7. Remove the blade assembly from the tool and replace it with a new one.
8. Align the inward bulge on the new blade assembly with the hole inside the
eccentric block assembly to install the new blade assembly into place.
9. Insert the two bushings into the two rounded rectangle separately.
HEDGE TRIMMER ATTACHMENT — HTA2000/HTA2000-FC/HTA2020/HTA2020-FC
Always wear gloves when handling the blade; these components are
Link Lever
Support Plate 2
Support Plate 1
Bushing
Short Screw
Bottom Cover
Support Plate 3
Long Screw
Eccentric Block Assembly
Blade Assembly
25

Publicité

loading

Ce manuel est également adapté pour:

Hta2000-fcHta2000Hta2020-fc