Benelli 502C 2020 Manuel Du Propriétaire page 116

Handlebar switches
Left
1. Horn switch " "
2. Dimmer/switch " / "
3. Turn signal switch " / "
4. Passing button
5. ABS switch (optional)
ABS
Right
4
2
5
3
1
1. Run/Start switch "
2. Hazard switch "
3. Electric ignition button
4. Adjustment / selection multifunction
meter button
Horn switch " "
Press this switch to sound the horn.
Dimmer/switch "
Set this switch to "
and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this swi-
tch to " ". To signal a left-hand turn,
push this switch to "
the switch returns to the center position.
To cancel the turn signal lights, push the
3 - 7
Instrument and control functions
switch in after it has returned to the cen-
ter position.
Passing button
1
Press this button (daytime) to enable la-
shing lights.
4
2
Run/Start switch " /
3
To crank the engine with the starter, set
this switch to " ", see page 5-1 for star-
ting instructions prior to starting the en-
/ " gine.
" Set this switch to " " to stop the engine in
case of an emergency, such as when the
vehicle overturns or when the throttle
cable is stuck.
Electric ignition button
Press this button to start the engine with
the starter device.
/ "
Hazard switch
" for the high beam
If necessary, press the switch to activate
the 4 arrows.
/ "
Adjustment / selection multifunction
meter button
". When released, In ODO mode, turn o the key. To adjust
the clock, turn on the key switch and im-
mediately long press the set button, when
EN
3
"