Remote Control - Uberhaus PC10-AMD Guide De L'utilisateur

1. Press the "TIMER" key in operating mode status to set the desired time.
2. Once the set time has elapsed, the unit will turn off automatically.
3. If you press the "POWER" key before the time has been elapsed, the set time will be
cancelled and the unit will turn off.
8. SLEEP CONTROL FUNCTION
1. In sleep comfort mode under the cooling setting - the temperature will be increased by 1ºC after 1
hour. Subsequently, the temperature will be increased by 2ºC after 2 hours. It will maintain this
setting without further changes.
2. Under dehumidification mode, sleep mode cannot be selected.
3. Low fan speed is the default setting under sleep comfort mode, but can be adjusted
4. In sleep comfort mode heating setting, the temperature will be decreased by 1ºC after
1 hour. Subsequently, the temperature will be decreased by 2ºC after 2 hours. It will
maintain this setting without further changes.
9. ALARM
When the water tank is full,"E4" will be displayed on the display panel. To resume operation,
please remove the rubber cap from the drain hose to drain out the water. After draining the
water out, please restart the unit and then the unit can operate normally.
7
REMOTE CONTROL FUNCTIONS
The remote control uses two
1.5 VOLT UM4 AAA CR03
- Do not mix old and new batteries
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh,
etc) batteries
type batteries
Stop/Start switch
MODE selector
Time programming
Automatic fan speed
High fan speed
Medium fan speed
Low fan speed
Sleep comfort mode selector
Temperature selector
8