Notice; Maintenance - Uberhaus PC10-AMD Guide De L'utilisateur

NOTICE

This unit allows the condensation to evaporate and flow out through the exhaust hose
automatically.
1. When the unit is in cooling mode, it is not necessary for the draining hose to be installed
Please make sure that the rubber cap is locked on the drain hose when the unit is running.
2. When the unit is in heating mode, please remove the rubber cap on the draining hole(1) and
attach a 17-mm inner-diameter draining hose (included) to maximize heating performance.
3. When the unit is in dehumidifying mode, please remove the rubber cap on the
draining hole (1) and attach a 17-mm inner-diameter draining hose (included) to
maximize dehumidifying performance.
• Please remove the air exhaust hose, connect the drain hose to the drain hole and
let the water drain into a container or outside.
※ When the water tank is full,"E4" will be displayed on the display panel. To resume
operation, please remove the rubber cap (②) of the drain hose to drain out the
water first. After drainage is complete, please restart the unit. Then, the unit can
operate normally.
9

MAINTENANCE

PLEASE DISCONNECT THE POWER CORD BEFORE CARRYING OUT
ANY MAINTENANCE TASKS.
AIR FILTER
The air filter located on one side of the unit can be removed, simply by
pulling the frame in an upward motion.
CONDENSER/EVAPORATOR
To clean, use a vacuum cleaner with a brush attachment.
CABINET
Wipe with a damp cloth and dry with a soft cloth.
To remove the air filter, please follow the arrow direction and push the
filter lightly. Then take filter out for cleaning.
10