PowerPeak FET8319P Mode D'emploi page 34

Step 1: assembling the front and rear stabiliser
Attach the front stabiliser (39) to the main frame (68) with two curved washers (13) and two cap nuts (48).
Remove the two allen bolts (14), spring washers (15) and washers (70) from the rear stabiliser (92). Attach the
rear stabiliser (92) to the main frame (68) with two allen bolts (14), two spring washers (15) and two washers
(70).
14
15
70
92
Step 2: assembling the handlebar post and connecting the hand pulse cable
STEP 1
Put the handlebar post (25) in a vertical position. Place the plastic cover (37) over the lower part of the
handlebar post (25). Keep the upper hand pulse cable (28) hanging from the handlebar post until it is
connected.
Connect the upper hand pulse cable (28) with the lower hand pulse cable (45).
Put the handlebar post (25) in the main frame (68) and secure the handlebar post (25) with six allen bolts (14),
six spring washers (15) and six curved washers (13).
STEP 2
All manuals and user guides at all-guides.com
13 48
39
25
15
14
13
28
37
45
68
49
34