Publicité
Installation
The chip dump should be placed on a firm leveled surface. If the unit is placed in close proximity to a wall,
partitions, kitchen furniture and decorative finish, it is recommended that they be made of non-combustible
material. If not, they should be clad with a suitable non-combustible heat-insulating material and fire prevention
should be installed.
Operation
Plug the unit into a grounded NEMA 5-15 electrical socket. The heating element will start to warm up and the
green light will turn on. When the product is finished being used, turn off the power switch and pull out the
power cord from the socket.
Maintenance
Unplug the chip dump from the wall socket. The chip dump should be cleaned using warm soapy water after
each use. Do not immerse the unit completely in water to clean. The appliance should not to be cleaned with a
water jet. Allow to thoroughly dry prior to use.
Troubleshooting
If the Chip Dump does not work, please check the following:
1. The power supply is correct and switched on.
2. The positions of switches are correct.
3. The elements are clear.
REFERENCE
Item Number Model Number
Description
Manufacturer Model Number
Chip Dump 22" x 13" / 565 x 337mm
23574
FW-CN-0902
PA10620
850W 120V/60/1
6
Publicité
