Electrolux 88031 K-IN Notice D'utilisation page 26

26 Installation Instructions
width of at least 3 mm.
Suitable isolation devices include line protecting cut-outs, fuses (screw type fus-
es are to be removed from the holder), earth leakage trips and contactors.
Sticking the seal in the rabbet
• Clean the rabbet in the work surface.
• Stick the one-sided self-adhesive sealing tape supplied onto the upper surface
of the rabbet along the edges of the cut-out section.
– Cut the sealing tape into four pieces relating to the length of the edges of
the rabbet.
– For the four corners of the rabbet the ends of the sealing tapes must be cut
into mitres. Do not stick the ends over one another.
– Stick the sealing tape flush into the corner of the rabbet, so that no silicon
compound can get under the glass ceramic when grouting.
– Don't stretch the tapes when sticking them on.