Télécharger Imprimer la page

Danby DBC057A1BSS Manuel Du Propriétaire page 7

Publicité

Les langues disponibles

Les langues disponibles

OPERATING INSTRUCTIONS
FUNCTION INSTRUCTION
The default temperature setting is 54°F (12°C).
The default temperature scale is °C.
Press the
°C/°F
button to change the temperature
scale.
The temperature can be set as low as 38°F (3°C) or
as high as 64°F (18°C)
Actual temperature inside the appliance can vary
based on ambient temperature, how often the door
is opened and how many warm beverages have
recently been added to the appliance.
INTERIOR LIGHT
The interior light will default to turning on and off
when the door is opened or closed.
The light switch can be used to set the light to
constant illumination when the door is both open
and closed.
If the door is open for more than 10 minutes, the
interior light will automatically turn off.
STORAGE INSTRUCTIONS
The maximum capacity of this appliance is 154
(355 ml) cans.
DEFROST
This appliance is equipped with an automatic
defrost function and does not require manual
defrosting. Defrost water from the appliance is
channeled into a drip tray located above the
compressor. Heat transfer from the compressor
causes the defrost water to evaporate.
POWER FAILURE
Most power failures are corrected within a few
hours and should not affect the temperature of your
appliance if you minimize the number of times the
door is opened. If the power is going to be off for
a longer period of time, take the proper steps to
protect your contents.
Note: Wait 3 to 5 minutes before attempting
to restart the appliance if operation has been
interrupted.
MOVING
• Make sure the appliance is empty.
• Secure the shelves with tape.
• Secure the door with tape.
• Turn the adjustable foot up to the base to avoid
damage.
• Protect the outside of the appliance with a
blanket or similar item.
• Be sure the appliance stays in the upright
position during transportation.
• If the appliance is placed on its back or side
during transportation, upon reaching the
destination, allow it to remain upright for 6
hours before plugging in to avoid damage to
internal components.
6

Publicité

loading