Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
PREPARING THE ENCLOSURE
Gloves and safety goggles should be worn during installation.
It is not recommended to install the appliance into a corner or directly beside a wall. The door will need to
be opened more than 90° to allow full extension of the shelves. If it is necessary to place next to a wall or
in a corner, leave at least 2-4 inches (5-10 cm) of space between the wall and the appliance to allow for
the door opening.
The cabinet opening must be at least 24 inches (61 cm) wide by 35 inches (88.9 cm) high by 25 inches
(63.5 cm) deep.
Note: The listed depth requirement is assuming that the electrical outlet is located in the adjacent cabinetry
or fl ush mounted in the rear wall, not surface mounted inside the enclosure.
If the electrical outlet is located inside adjacent cabinetry, cut a 1.5 inch (3.8 cm) diameter hole to admit
the power cord. If the cabinet wall is metal, the hole edge must be covered with a bushing or grommet.
1.5 in (3.8 cm) diameter
35 in
*If electrical outlet in
(88.9 cm)
adjacent cabinetry
Electrical Access
Electrical Access
25 in
(63.5 cm)
2 in (5 cm)
6 in
(15.2 cm)
24 in (61 cm)
4
REQUIRED TOOLS
• Safety goggles
• Gloves
• Tape measure
• Carpenter square
• Level
• Flashlight
• Electric drill with hole bit
90°
Publicité
