EGO POWER+ HTA2000-FC Mode D'emploi page 24

GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use a clean cloth to remove dirt, dust, oil, grease, etc.
WARNING:
water or other liquids.
CLEANING
◾
Use a soft brush to remove debris from all air intakes and cutting blades.
◾
To remove pitch and other sticky residue, spray the blades with resin solvent. Run
the motor briefly so that the solvent is evenly distributed.
◾
Do not use any strong detergents on the plastic housing or the handle. They can
be damaged by certain aromatic oils, such as pine and lemon, and by solvents
such as kerosene. Moisture can also cause a shock hazard. Wipe off any moisture
with a soft dry cloth. NEVER use water for cleaning the tool.
All hedge trimmer service, other than the items listed in these maintenance instructions,
should be performed by competent hedge trimmer service personnel.
REPLACING THE BLADE
WARNING:
very sharp and may contain burrs.
14
24
HEDGE TRIMMER ATTACHMENT — HTA2000/HTA2000-FC
When cleaning the hedge trimmer attachment, DO NOT immerse it in
Always wear gloves when handling the blade; these components are
Link Lever
Support Plate 2
Support Plate 1
Bushing
Short Screw
Bottom Cover
Support Plate 3
Long Screw
Eccentric Block Assembly
Blade Assembly