Listening To The Radio; Reception Indications - Sony XAV-68BT Mode D'emploi

Masquer les pouces Voir aussi pour XAV-68BT:

Mode d'emploi (108 pages)

100

101

102

103

104

Table des Matières

Les langues disponibles

Touch [Pairing].

The unit enters pairing standby mode.

Perform the pairing procedure on the

BLUETOOTH device to detect this unit.

Select "SONY:XAV-68BT" shown in the

display of the BLUETOOTH device.

If passkey* input is required on the

BLUETOOTH device, input [0000].

* Passkey may be called "passcode," "PIN code,"

"PIN number," "password," etc., depending on the

BLUETOOTH device.

Select this unit on the BLUETOOTH device

to establish the BLUETOOTH connection.

lights up when the connection is made.

Note

While connecting to a BLUETOOTH device, this unit

cannot be detected by another device. To enable

detection, terminate the current connection.

Connecting with a paired BLUETOOTH

device

This chapter explains how to connect manually to

registered BLUETOOTH devices.

Make sure that the BLUETOOTH signals

both on this unit (page 18) and the

BLUETOOTH device are activated.

on the status bar indicates that the

BLUETOOTH signal on this unit is on.

Operate the BLUETOOTH device to

connect to this unit.

appears.

When the ignition is turned to on with the

BLUETOOTH signal activated, this unit searches for

the last-connected BLUETOOTH device, and

connection is made automatically if possible.

Note

If this unit cannot detect the last-connected

BLUETOOTH device, touch [Reconnect] to search for the

last-paired device again.

If the problem is not solved, follow the pairing

procedure.

To install the microphone

To capture your voice during handsfree calling, you

need to install the microphone (supplied).

For details on how to connect the microphone, refer

to the supplied "Installation/Connections" guide.