GreenWorks Pro LMB408 Manuel D'utilisation page 13

11 TROUBLESHOOTING
Problem Possible cause
The handle is not The bolts are not
in position. engaged correctly.
The machine does The battery ca-
not start. pacity is low.
The bail switch is
defective.
The battery key is
not put in.
The machine cuts The lawn is rough. Examine the mow-
grass unevenly.
The blade height is
not set correctly.
The machine does Wet grass clip-
not mulch correct- pings attach to the
ly. deck.
The mulch plug is
missing.
The machine is The grass is too
hard to push. tall, or the blade
height is too low.
The grass catcher
and the blade
drags in thick
grass.
There is a high vi- The blade is un-
bration in the ma- balanced and
chine. worn.
The motor shaft is
bent.
English
Problem
The machine stops
Solution
during mowing.
Adjust the height
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
Charge the battery
pack.
Replace the bail
switch.
* If you cannot find the solution to these problems, go to the
Put in the battery
service center.
key.
12
ing area.
Voltage
Move the wheels
to a higher posi-
Battery model
tion.
Wait until the
Charger model
grass dries before
mowing.
No load speed
Install the mulch
Height adjust-
plug.
ments
Increase the blade
Self-propelled
height.
speed
Functions
Empty the grass
clippings from the
grass catcher.
Weight (without
battery pack)
Replace the blade.
Double-insulated
construction
1. Stop the mo-
13
tor.
2. Remove the
safety key and
battery pack.
3. Disconnect the
power source.
4. Inspect for
damage.
5. Repair the ma-
chine before
you start it
Greenworks hereby warranties this product, to the original
again.
purchaser with proof of purchase, for a period of four (4)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
13
Possible cause
The blade height is
too low.
The battery pack is
out of power.
The grass clip-
pings attach to the
deck or the blade.
Operation temper-
ature of the ma-
chine is too high.
TECHNICAL DATA
80 V
BAB726/BAB727 and other BAB ser-
ies
2901402/CAB801 and other CAB ser-
ies
2800 RPM
1 3/8 - 3 3/4" (3.5 - 9.5) cm
2.24-4.32 fps (0.7-1.35) m/s
3-in-1 Mulch & Rear Bag & Side Dis-
charge
62.8 lbs (28.5) kg
LIMITED WARRANTY
EN
Solution
Increase the blade
height.
Charge the battery
pack.
Remove the bat-
tery pack and
check the deck.
Cool the machine.