7. Take out the left upper hinge, left upper hinge cover, and right decorative
cover from the accessory bag. Install the freezer door on the middle hinge, and
install the left upper hinge, left hinge cover and hole cap. Finally, install the right
decorative cover on right side of the end cap of freezer door.
2.4 Changing the Light
Disconnect the mains supply before carrying out the bulb replacement.
Hold and lift up the light bulb cover. Remove the old bulb by unscrewing it in an
anti-clockwise direction. Replace with a new bulb by screwing it in a clockwise
direction making sure that it is secure in the bulb holder. Refit the light cover
and re-connect your Fridge to the mains supply. (The content above is only for
reference. The actual configuration will depend on the physi cal product or
statement by the distributor)
2.5 Starting
595mm
991mm
2.6 Energy saving tips
The appliance should be located in the coolest area of the room, away from
•
heat producing appliances or heating ducts, and out of the direct sunlight.
Let hot foods cool to room temperature before placing in the appliance.
•
Overloading the appliance forces the compressor to run longer. Foods that
freeze too slowly may lose quality, or spoil.
•
Be sure to wrap foods properly, and wipe containers dry before placing them in
the appliance. This cuts down on frost build-up inside the appliance.
•
Appliance storage bin should not be lined with aluminum foil, wax paper, or
paper toweling. Liners interfere with cold air circulation, making the appliance
less efficient.
•
Organize and label food to reduce door openings and extended searches.
Remove as many items as needed at one time, and close the door as soon as
possible.
Before initial start, keep the refrigerator still for half an
hour before connecting it to power supply.
Before putting any fresh or frozen foods, the refrigerator
shall have run for 2-3 hours, or for above 4 hours in
summer when the ambient temperature is high.
Spare enough space for convenient opening of the
doors and drawers or statement by the distributor.
The pictures above are only for
reference. The actual configuration will
depend on the physical product or
statement by the distributor.
13
V.2