Imetec E7804 Mode D'emploi page 16

WARNING! DO NOT use water from dryers, air-conditioners,
water from tumble dryers, filtered water with water softeners
and rain water.
EN
The reservoir may contain some water as each product is tested before being put on the market.
FILLING THE TANK
Check that the power supply cable with plug (8) is plugged into the socket.
Open the water fill cover (9).
Pour water into the tank (6) very slowly to avoid overflowing.
Do not exceed the maximum filling level indicated.
Close the water fill cover (9).
NOTE: The tank can also be filled during use.
SELECTING THE TEMPERATURE
Plug the power supply cable with plug (8) into the socket.
Press the ON/OFF switch (1) to turn the product ON.
Light (2) comes ON to indicate that the product is operating.
Set the temperature according to the type of fabric in line with the international symbols shown on the
labels; using the adjustment knob (13)..
The plate temperature LED (10) indicates that the iron is warming up.
Wait for the plate temperature LED (10) to go off before starting to iron.
It is recommended that you place a cloth between the iron and the fabric when using the iron
for the first time.
Before starting ironing, direct a jet of steam onto the cloth by lifting the iron slightly so that any
residual condensation comes out.
Fabrics with the following symbols may not be ironed:
IRONING WITH STEAM
Press the steam request button (12) to iron with steam.
NOTE: Steam can only be used at the highest temperatures, between the position with
the 3 dots and the maximum temperature position, as indicated by the symbol on the
temperature adjustment knob (13).
If the selected temperature is too low, water droplets may drip from the plate.
The soleplate temperature LED flashes intermittently while ironing, thereby indicating that the
selected temperature is maintained.
IRONING WITHOUT STEAM (DRY)
Avoid pressing the steam request button (12) to iron without steam.
SUPER-STEAM FUNCTION
Press the super steam switch (3) to increase the amount of steam.
When the super-steam light (4) is ON, it indicates that the function is active.
14