Whirlpool GU3200XTPS5 Instructions D'installation page 8

2. Wood cabinet:
Sand hone unfiH
smooth.
Option 2, Power supply cord method:
NOTE: A mating, three prong, ground-type wahl receptacle
is required in a cabinet next to the dishwasher opening.
1. (&8Drill cm)a lol/2"hole in I optional
preferred I
the cabinet rear ...... ,I_ ens Ioca_
or side. Preferred i:_[_il
o o o t,ooo, ,:::,
Hocafions are ) _
shown
MetaH cabinet: Cover hone with grommet (Part No.
302797) incHuded with power suppHy cord kit.
[nstal[ the water line
1=
NelpfuITip: Routing the water Hine through the Heft side
of cabinet opening vvHH make water connection easier.
DriHH a minimum 1/2" (1.3 cm) hone in the cabinet side,
rear or fHoor. Preferred and opfionaH Hocafions are
shown,
preferred
locations
optional
locations
2. Measure overaHHHength
of copper tubing
require&
3. Attach copper tubing
to the water Hine with a
manuaH shutoff vaHve.
copper
tubing
4. Slowly feed copper
tubing through hole in
cabinet. Copper tubing will bend and kink easily, so be
gentle.The copper tubing should be far enough into the
cabinet opening to connect it to dishwasher inlet on the
front left of the dishwasher.
5. Turn water shutoff vaHve to "ON" position. Hush water
into a shaHHow pan to get rid of particHes that may clog
the inHet vaHve.
6. Turn shutoff valve to "OFF" position.
Install the drain hose
iMPORTANT: AHways use a new drain hose.
1. DriHH a 1ol/2" (3.8 cm)
diameter hone in
cabinet waHH or floor on
the side of the opening
cHosest to the sink.
2. Connect drain hose to waste tee or waste disposer
using one of the following methods:
® Option 1, Waste disposer- with air gap
o Option 2, No waste disposer- with air gap
o Option 3, Waste disposer - no air gap x
Option 4, No waste disposer - no air gap x
_an air gap is recommended
Helpful Tip:To reduce the vibration of the hose, keep
the hose away from the floor and the edge of the hone
where it passes through the cabinet.
Option 1, Waste disposer = with air gap:
1. Remove the disposer knockout pHug. Cut end of drain
hose if needed (do not cut ribbed section).
2. Attach drain hose to air gap with Harge spring4ype
champ. If the drain hose was cut, use a lq/2" to 2"
(&8 to 5 cm) screw-type cHamp x,
3. Use a rubber hose connector _ with spring or screw-
type clamps x-to connect air gap to disposer inlet.
This connection must be before the drain trap and at
Heast 20" (50.8 cm) above the floor where dishwasher
wiHHbe instaHHe&
drain hose-
_eut here if needed
rubber hose
connector
• large
spring-type
clamp
hose
drain traF
4=
insert drain hose
through hone cut in
cabinet to the front
center of opening where
drain connection wiHHbe
made.
drain hose
Parts available from local plumbing supply stores