Beyerdynamic TG 1000 Guide De Démarrage Rapide page 11

Quick Start Guide TG 1000 – Diversity Receiver
Where to Place the Receiver
• Place the receiver in the same room where the transmission takes place.
• Place the receiver as close as possible to the transmitter. For optimal reception a free line of sight
is advisable between transmitter and receiver.
• Do not place the receiver near digitally controlled devices.
How to Connect the Antennae
• Connect the supplied antennae to the antenna inputs A and B
60°) in the shape of a "V".
Important: For the diversity operation it is absolutely necessary to connect both antennae!
A weighting circuit ensures that the antenna is selected that supplies the better signal.
• As an alternative you can mount the antennae on the front of the receiver. Please use the appropriate
antenna front mounting kit.
• If the reception is not optimal there where the receiver is placed, you can operate the receiver with
remote antennae (available as optional accessories).
How to Connect the Receiver
• The receiver is provided with balanced audio outputs.
• Connect the balanced XLR
microphone inputs of a mixing console or amplifier.
• Connect the power cable to the mains connection
rating of the receiver matches that of the AC mains outlet you are to use. If you connect the receiver
to the wrong voltage, you may seriously damage it.
How to Operate the Receiver
• After having mounted and connected the receiver, turn it on with the on-off switch
• The standard display
received on the selected frequency, the display background will be black. If there is no valid
transmitter signal available, the colour of the display background will turn white. In this case there
will be no audio signal.
• By default it is displayed:
1. line: the currently selected name (e.g. name of the artist)
2. line: the currently selected frequency
3. line: the currently selected frequency group and channel
4. line: when valid transmitter signal is available:
when no valid transmitter signal is available: No Tx or Enc Err
• All buttons on the front of the receiver are backlit in white. When a button is pressed or activated,
the backlit light will turn red.
• For turning the receiver off, use the on-off switch
• Via an infrared interface the receiver can transmit the frequency and other settings such as encryption
or power lock of each channel to the appropriate transmitter.
• Select an appropriate frequency for both channels. Please observe country-specific regulations.
• In order to transmit the frequency and other settings to the transmitter, press the appropriate button
of synchronisation
• In the battery compartment of the handheld or beltpack transmitter you will find an infrared
interface.
• When the pressed button of synchronisation
handheld transmitter
turned on transmitter directly in front of the infrared interface
• When the message "SYNC successful" is displayed
settings have successfully been transmitted to the transmitter.
and the jack output
for each of the two channels will be shown. If a valid transmitter signal is
for channel 1 or 2.
or beltpack transmitter
and set them at an angle (approx.
of the channels 1 and 2 to the balanced
and to a mains socket. Verify that the voltage
Battery status, transmitter type, microphone
capsule and gain in dB
. The buttons will no longer be backlit.
is backlit in red, hold the infrared interface of the
in the opened battery compartment of the
of the receiver.
, the process is finished. Frequency and other
11
.