Garland MULE 961 QG Manuel D'instructions page 44

English
6.2.5. MOUNTING THE HANDLE
M8x20
6.2.6. MOUNTING THE HANDLEBAR
Place the bottom handle (L) and once the two M10x65
screws have been placed, tighten the nuts.
M10x65
Place on the bottom handle (L), the dented base (K),
the top handle (Z), the washer (J) and screw without
tightening the wing screw (G).
Install the handle in the
engine frontal using the
M8x20 screws provided.
44/184
Adjust the handle to the position where you are most
comfortable to carry out your work and tighten the
wing nut (g) so as to leave the handlebar in place.
6.3. FUEL AND OIL
IMPORTANT: The fuel used for this machine is
highly flammable. If the fuel or the machine
ignites, put out the fire with a dry powder
extinguisher.
Petrol and oil are extremely flammable and
explosive under certain conditions. Do not
smoke and keep flames, sparks or heat away
from the machine.
Use unleaded gasoline 95 octane.
Do not use fuel that has been stored for longer than
2 months. A fuel stored for too long will cause the
starting of the machine to be more difficult and result
in unsatisfactory engine performance. If the fuel
has been in the machine's tank for longer than two
months, empty the tank and replace it with fuel in
perfect condition.
6.3.1. FILLING THE FUEL TANK
1. Choose a suitable area to perform this operation.
2. Remove the fuel tank cap and fill with fuel.
3. Tightly close the fuel tank's cap and remove all the
fuel that spilled with a dry cloth.
WARNING:
Stop the engine before refueling.
Do not start the machine in an enclosed room or
space. The exhaust gases and fumes from the
fuel and oil contain carbon monoxide and harmful
chemicals.